Gvrp Config - Black Box 12-Port 1000BASE-TX L2 Managed PoE Switch User Manual

12-Port 1000BASE-TX L2 Managed PoE Switch with 2 SFP Dual Media Ports
4.14.1 GVRP C
ONFIG
Parameter

GVRP Config

GVRP State Setting
Join Time
Leave Time
Leave All Time
Default Applicant Mode
66
Table 4-33. GVRP Configuration screen options.
Description
In the function of GVRP Config, it is used to configure each port's
GVRP operation mode, in which there are seven parameters
needed to be configured described below.
This function is simply to let you enable or disable GVRP function.
You can pull down the list and click the Downward arrow key to
choose Enable or Disable. Then, click the Apply button, the
system will take effect immediately.
Used to declare the Join Time in unit of centisecond. Valid time
range: 20 –100 centisecond, Default: 20 centisecond.
Used to declare the Leave Time in unit of centisecond. Valid time
range: 60 –300 centisecond, Default: 60 centisecond.
A time period for announcement that all registered device is going
to be de-registered. If someone still issues a new join, then a
registration will be kept in the switch. Valid range: 1000-5000 unit
time, Default: 1000 unit time.
The mode here means the type of participant. There are two
modes, normal participant and non-participant, provided for the
user's choice.
Normal: It is Normal Participant. In this mode, the switch
participates normally in GARP protocol exchanges. The default
setting is Normal.
Non-Participant: It is Non-Participant. In this mode, the switch does
not send or reply any GARP messages. It just listens messages
and reacts for the received GVRP BPDU.