Engine Installation - Honda NHSO aeroBO 1983 Shop Manual

ENGINE REMOVAL/INSTALLATION
Unscrew the nut and remove the engine mounting
bolt.
Slide the engine toward the rear.
Disconnect the oil control cable.
Disconnect the oil tube.
Remove the engine.

ENGINE INSTALLATION

The installation sequence is essentially the reverse
order of removal.
Tighten the engine mounting bolt and rear shock
absorber upper and lower bolts to the specified
torque values.
TORQUE:
Engine mounting bolt: 27-33 N·m
(2.7-3.3 kg-m, 20 - 24 ft-lb)
Rear shock absorber
upper mounting bolt: 30 - 40 N·m
(3.0-4.0 kg·m, 22-29 ft-lb)
Rear shock absorber
lower mounting bolt: 20-30 N·m
(2.0-3.0 kg
Perform the following inspections and adjustments
after installation:
•
Wire and cable routing (Page 1·8, 1 -9)
• Throttle cable (Page 3-4)
•
Oil control cable (Page 2·4)
•
Oil pump bleeding/priming (Page 2-3)
•
Rear brake adjustment (Page 3-9)
5-4
- m, 1 4-22 ft·lb)
.
52
ENGINE MOUNTING BOLT
O I L TUBE
Date of Issue: May, 1 983
© HONDA MOTOR CO., L TO.
--- ..