Carburetor Idle Speed - Honda NHSO aeroBO 1983 Shop Manual

HONDA
NHSO
at
Disconnect the oil line the bottom of the oil tank
by loosening the clip.
Remove the oil strainer.
Clean the oil strainer with compressed air. Replace
the oil strainer if necessary. The installation sequence
is essentially the reverse order of removal.
Fill the tank with the recommended oil up to the
proper level and bleed air from the oil pump and oil
line (Page 2·3).
NOTE:
•
Connect the oil line securely.
•
Check for leaks.
MUFFLER DECARBONIZATION
Remove the muffler (Page 13·2).
Remove the carbon from the muffler.
Reinstall the muffler (Page 13·3).

CARBURETOR IDLE SPEED

NOT E :
•
Inspect and adjust idle speed after all other
engine adjustments are within specifications.
•
The engine must be warm for accurate ad·
justment. Ten minutes of stop-and-go riding
is sufficient.
Remove the left side cover.
Warm up the engine and place the scooter on its
center stand.
Turn the throttle stop screw as required to obtain the
specified idle speed.
IDLE rpm
SPEED: 1,800± 100
Date of Issue: May, 1983
© HONDA MOTOR CO., L TO.
O I L LINE
27
MAINTENANCE
CLIP
A IR GUN
3 - 7