Honda NHSO aeroBO 1983 Shop Manual page 175

DRIVEN PULLEY
BALL BEARING
MOVABLE
DRIVEN
FACE
GUIDE PIN AND ROLLER
The driven pulley and clutch weights are attached over the drive shaft. The clutch outer is attached to the drive shaft with a
nut. The force of the driven face spring·is always exerted on the movable face to push it against the driven face. Therefore,
when engine speed is increased, the driven pulley turns and the clutch connects automatically. The effective diameter of the
drive pulley is increased. The movable face is forced outward by means of the belt until an equilibrium is reached between the
torque tension of the belt and force of the spring. When this occurs, the drive ratio decreases and less torque is delivered to
the final reduction.
Date of Issue: May, 19B3
© HONDA MOTOR CO., L TO.
185
TECHNICAL FEATURES
DRIVE SHAFT
GUIDE ROL�ER
1 7- 5