Honda NHSO aeroBO 1983 Shop Manual page 165

E LECTRICAL EQUIPMENT
OIL LEVEL INDICATOR UNIT
O I L LEVEL SENSOR INSPECTION
Disconnect the coupler and remove the sensor.
Lower the float fully until it will no longer go.
Measure the resistances between the terminals as
shown.
(-1
Terminal
(+)
Green/Red (+I to Black
Green (-) to Black
O I L LEVEL I N D ICATOR SWITCH
I NSPECTION
Connect the coupler and turn the ignition switch
ON. With the float raised fully, measure the resist­
ance between the terminals.
Green/Red (+) to Black
(-1
NOTE:
Operate the turn signals to see that the bat­
tery circuit is normal, then perform the fol­
lowing inspection.
Raise and lower the float to make sure that the oil
level indicator lamp blinks.
NOTE:
Should the lamp fail to go on and go out as
the float is moved up and down, check for
loose connections and repeat the above proce­
dure.
1 5 - 1 8
O I L LEVEL SENSOR
Resistance
5-15
n
00
340 .U approx.
176
HONDA
NHSO
GR EEN/RED
BLACK
±
4.5 .0 mm
1
0.0 4 in)
( 0. 18
±
O I L LAMP
Date of Issue: May, 1983
© HONDA MOTOR CO., LTD.
BLACK