Honda NHSO aeroBO 1983 Shop Manual page 89

DRIVE AND D R I V E N PULLEYS/KICK STARTER/CLUTCH
Position the driven face assembly, spring and guide
plate assembly on the clutch spring compressor.
Compress the spring by turning the handle.
Install and tighten the 28 mm special nut.
Use a beam type torque wrench 12-14 inches long.
TORQUE: 35-40 N·m
(3.5-4.0 kg·m, 25-29 ft·lb)
CLUTCH/ D R I V E N PULLEY
INSTALLATION
Install the driven pulley on the drive shaft.
Install the clutch outer and torque the nut while
holding the clutch outer with the universal holder.
TORQUE: 35-40 N·m
(3.5-4.0 kg·m, 25-29 ft·lb)
Install the driven face (Page 8·6).
Install the left case cover (Page 8·7).
8 - 2 2
LOCK NUT WRENCH, 39 mm
0791 6-1870001
--
CLUTCH SPR ING COMPRESSOR
07960-KJ90000
CLUTCH/DRIVEN PULLEY
CLUTCH OUTER
94
UNIVERSAL HOLDER
077 25-0030000
Date of Issue: May, 1 983
© HONDA MOTOR CO., LTD.