Honda NHSO aeroBO 1983 Shop Manual page 87

D R I V E AND D R I V E N P U L LEYS/KICK STA RTER/CLUTCH
Inspect the driven face assembly for wear or dam­
age.
Measure the driven face
0.0.
LIMIT: 33.930
SERVICE
mm
Inspect the movable driven face for wear or damage.
Measure the movable driven face
LIMIT: 34.060
SERVICE
mm
Check the guide groove for wear.
Check the oil seal for wear, damage or other faults.
D R I V E N FACE ASSEMBLY
Using Bearing Driver (07945-GCSOOOO), install
the outer bearing in the movable driven face with
the sealed end facing out.
Seat the snap ring in its groove.
Pack all bearing cavities with 5.0-5.5 g of grease.
NOTE:
Specified grease: Nippon Sekiyu
LIPANOX DELU X E 3
8 - 2 0
( 1 .3358 in)
1.0.
( 1 .3409 in)
OUTER BEARING
92
HONDA
NHSO
SNAP RING
Date of Issue: May, 1983
© HONDA MOTOR CO., TO.
L