Removing A Processor Card - IBM eServer pSeries 610 6C1 Installation Manual

Removing a Processor Card

1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 34.
2. If you have not already done so, unplug the system unit power cables from the
electrical outlets.
3. If your server is a Model 6C1 (rack mount), place the server in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 35.
4. If you have not already done so, remove the service access cover as described in
"Removing the Service Access Covers" on page 37.
5. Remove the processor and memory card cover as described in "Removing and
Replacing Processor and Memory Card Cover" on page 41.
6. The processor card is secured in place with retention latches, one on each end of
the card. Open the retention latches.
Attention: To prevent damage to the card and the card connectors, open or close
7. Remove the card from the connector. Be sure to store the processor card in a safe
place.
8. If you have other options to install, refer to "Option List" on page 36.
44
Installation Guide
the retention latches at the same time.