IBM eServer pSeries 610 6C1 Installation Manual page 104

Ibm eserver pseries 610 unix server installation guide
Hide thumbs Also See for eServer pSeries 610 6C1:
Table of Contents

Advertisement

Step 4
Determine if the operating system is accepting commands.
Is the operating system accepting commands?
NO
YES
Step 5
Diagnostic tests can be run on many resources while the operating system is running.
However, you can obtain more extensive problem isolation by running Online
Diagnostics in Service mode.
Do you want to run the Online Diagnostics in Service mode?
NO
YES
Step 6
This step invokes the Online Diagnostics in concurrent mode.
1. Log in as root user.
2. Enter the diag command.
3. Wait until the Diagnostic Operating Instructions are displayed, or wait for three
minutes.
Are the Diagnostic Operating Instructions displayed without any obvious console
display problems?
NO
YES
88
Installation Guide
The system must be turned off in order to run diagnostics.
Verify with the system administrator and users that the system may
be turned off. If so, then turn off the system unit and go to "Step 7" on
page 89.
Go to "Step 5".
Go to "Step 6".
Do the following to shut down your system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. 3. Go to "Step 7" on page 89.
Do the following to shut down your system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. 3. Go to "Step 7" on page 89.
Go to "Step 10" on page 90.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eserver pseries 610 6e1

Table of Contents