IBM eServer pSeries 610 6C1 Installation Manual page 80

1. If the server is a Model 6E1, unlock and open the server door.
Attention:
than two minutes without either a drive or a filler panel installed for each bay.
2. Log in as root user.
3. At the command line, type smitty.
4. Select System Storage Management (Physical and Logical Storage).
5. Select Removable Disk Management.
6. Select Remove a Disk.
7. Select the desired disk from the list on the screen and press Enter.
8. Follow the instructions on the screen to remove the drive.
9. When you are asked "Are you sure?" answer "Yes" and press Enter. The power
LED on the drive that you selected turns off.
10. Remove the defective hard disk drive (2) by placing the handle (3) on the drive to
the open position (perpendicular to the drive) and pulling the hot-swap tray from
the bay.
11. Repeat the previous steps for all the drives you are removing.
12. Press F10 to exit smitty.
13. If you have other options to install, refer to "Option List" on page 36.
If you do not have other options to install, close and lock the server door.
64
Installation Guide
To maintain proper system cooling, do not operate the server for more