IBM eServer pSeries 610 6C1 Installation Manual page 22

2. Attach the slide rails to the rack.
a. Insert the left slide-rail rear bracket pin into the hole between the two cage nuts
b. Pull the slide-rail front bracket to the front of the rack; insert the front bracket pin
c. Do the same for the right slide rail.
d. From the outside of the rack enclosure, insert two M6 by 16-mm screws through
6
Installation Guide
for the slide rail at the rear of the rack. The two holes in the rear bracket line up
with the cage nuts.
into the hole above the cage nuts for the slide rail. The two holes in the front
bracket line up with the cage nuts.
2
1
1 Left slide rail
2 Left rear
3 Left front
each slide-rail bracket and cage nut; then, tighten the screws finger tight.
3