b. Clip the rails onto the sides of the drive.
9. Place the drive so that the slide rails engage in the bay guide rails. Push the drive
into the bay until it clicks into place.
10. Connect one of the connectors on the SCSI cable for the non-hot-swap drive bays
to the back of the drive.
11. Connect a power cable to the back of the drive. Power cables for non-hot-swap
drives are preinstalled in the server. The connectors are keyed and can be inserted
only one way.
12. If you have other options to install, refer to "Option List" on page 36.
If you do not have other options to install; replace the bezel as described in
"Replacing the Bezel" on page 75.
Chapter 3. Installing Options in Your System
67