Step 2. Need Help; Step 3. Read The Safety Notices - IBM eServer pSeries 610 6C1 Installation Manual

Step 2. Need Help?

If you encounter difficulties while setting up your system unit, contact your sales
representative for assistance.

Step 3. Read the Safety Notices

Before continuing, read the following safety information. Do not plug any cables into the
system unit, adapters, or electrical outlets until you have reviewed this information.
Make sure none of the power cords are connected before continuing to the next step.
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage
on metal parts of the system or the devices that attach to the system. It is the
responsibility of the customer to ensure that the outlet is correctly wired and
grounded to prevent an electrical shock.
Before installing or removing signal cables, ensure that the power cables for
the system unit and all attached devices are unplugged.
When adding or removing any additional devices to or from the system,
ensure that the power cables for those devices are unplugged before the
signal cables are connected. If possible, disconnect all power cables from the
existing system before you add a device.
Use one hand, when possible, to connect or disconnect signal cables to
prevent a possible shock from touching two surfaces with different electrical
potentials.
During an electrical storm, do not connect cables for display stations, printers,
telephones, or station protectors for communications lines.
CAUTION:
This product is equipped with a three–wire power cable and plug for the user's
safety. Use this power cable with a properly grounded electrical outlet to avoid
electrical shock.
DANGER
To prevent electrical shock hazard, disconnect all power cables from the
electrical outlet before relocating the system.
Chapter 1. Setting Up the System
3