IBM eServer pSeries 610 6C1 Installation Manual page 96

6. Locate the battery on the system board.
Processor Card
Connectors
7. If needed, remove any processor cards or memory card to gain access to the
battery.
8. Pry the battery out of its mount using your fingernail or a small blunt object. After
the top of the battery has cleared the plastic mount, pull it up and out of the
system board.
9. Ensure that the battery polarity is correct.
10. Using your thumb, gently press the battery into the battery mount. Use your index
finger to support the back of the battery mount during this operation.
11. Replace any removed processor or memory cards.
12. Replace the processor and memory card cover as described in "Removing and
Replacing Processor and Memory Card Cover" on page 41.
13. Replace the system unit covers as described in "Replacing the Service Access
Covers" on page 77.
14. Reset the time and date.
15. If running AIX, the bootlist command may have to be run from AIX while logged in
as root user. This restores the custom boot list and allow the option of Select
Software under multiboot to start the operating system. The IP (Internet Protocol)
parameters might have to be rebuilt also.
80
Installation Guide
Memory Card
Connector
Plastic Battery Mount
Battery
Rear Battery Clip
Battery P/N
15F8409