Step 6. Install The System In The Rack Enclosure - IBM eServer pSeries 610 6C1 Installation Manual

Step 6. Install the System in the Rack Enclosure

Attention:
due to uneven mechanical loading when installing this unit in a rack. If the rack has a
stabilizer it must be firmly attached before installing or removing this unit.
1. Mount the server on the slide rails.
a. Extend the slide rails fully from the rack until the slide rails lock.
b. Rest the blue wheel-shaped knobs (1) on the slide rails at a point close to the
c. Lower the front of the server until the bottom notch in each chassis bracket fits
8
Installation Guide
Care should be taken to ensure that a hazardous condition is not created
rack.
into the top notch in the slide rail end.
Slide the server backward or forward as necessary until the notches meet.
1