IBM eServer pSeries 610 6C1 Installation Manual page 107

Step 12
1. If the terminal type has not been defined, use the Initialize Terminal option on the
Function Selection menu to initialize the operating system environment before you
can continue with the diagnostics. This is a separate operation from selecting the
console display.
2. Select Diagnostic Routines.
3. Press the Enter key.
4. In the following table, find the menu or system response you received when you
selected Diagnostics. Follow the instructions given in the Action column.
System Response
The Diagnostic Mode Selection menu is
displayed.
The Missing Resource menu is displayed.
The New Resource menu is displayed.
The system does not respond to selecting
diagnostics.
Action
Select Problem Determination and go to "Step
13" on page 92.
Follow the displayed instructions until either the
Diagnostic Mode Selection menu or an SRN is
displayed.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to "Step 13" on page 92.
If you get an SRN, record it, and go to "Step
15" on page 92.
Follow the displayed instructions.
Note: Devices attached to serial ports S1 or
S2 do not appear on the New Resource menu.
Also, ISA adapters do not appear unless they
have been identified and configured.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to "Step 13" on page 92.
If you get an SRN, record it, and go to "Step
15" on page 92.
If you do not get an SRN, go to "Step 18" on
page 93.
Go to "Step 11" on page 90.
Chapter 5. Hardware Problem Determination
91