Placing The Model 6C1 In The Service Position - IBM eServer pSeries 610 6C1 Installation Manual
Ibm eserver pseries 610 unix server installation guide
Hide thumbs
Also See for eServer pSeries 610 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Service manual (377 pages)
Table of Contents
Advertisement
Placing the Model 6C1 in the Service Position
Attention:
Care should be taken to ensure that a hazardous condition is not created
due to uneven mechanical loading when placing the server in the service position. If the
rack has a stabilizer it must be firmly attached before placing the server in the service
position.
Before doing any actions inside the Model 6C1, you must put the server in the service
position. To place the server in the service position, release the left and right side
latches and pull the server toward the front until it is fully extended. When the server is
fully extended, safety latches on the slide rails lock into place. This prevents the server
from being accidentally pulled out too far and dropped.
1
After completing actions, return the server to the normal position by pressing in on the
safety latches (1).
35
Chapter 3. Installing Options in Your System
Advertisement
Table of Contents
