IBM eServer pSeries 610 6C1 Installation Manual page 73

12. Install the adapter.
a. Carefully grasp the adapter (4) by its top edge or upper corners, and align it
with the expansion slot on the system board.
b. Press the adapter firmly into the expansion slot.
Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector.
Incomplete insertion might cause damage to the system board or
the adapter.
c. Lower the tab (2) on the adapter guide over the tab on the top corner of
adapter. Rotate the adapter retention latch (1) clockwise until it snaps into
place.
Attention: Power cannot be restored to the adapter slot if the tab is not
lowered into place.
d. Close the adapter retainer flap (3) if previously opened.
13. Connect any needed cables to the adapter.
Attention: Route cables so that the flow of air from the fans is not blocked.
14. If you have other options to install, refer to "Option List" on page 36.
If you do not have other options to install, replace the covers as described in
"Replacing the Service Access Covers" on page 77.
Chapter 3. Installing Options in Your System
57