Step 9. Connect The Graphics Display - IBM eServer pSeries 610 6C1 Installation Manual

Step 9. Connect the Graphics Display

Note:
If you ordered a graphics display with your system unit, the graphics adapter has been
set to use the highest display resolution and refresh rate available for that display. If
you want to:
v Attach another display to your system unit
OR
v Change the default display resolution or refresh rate
after completing the installation steps, refer to the Customer Installable Options Library
CD-ROM for the documentation for your graphics adapter.
As shown in "Step 10. Attach the Display Cable Toroid" on page 14, connect the
graphics display cable to the back of the display and to the graphics adapter connector.
Consult the "About Your Machine" document for the locations of installed adapters.
For more information about your display, refer to the documentation included with the
display.
Note: Some displays require an additional cable.
If you are using an ASCII terminal with a keyboard as the console for this
system, go to "Step 12. Connect the Serial and Parallel Devices" on page 16.
If you are using a graphics display with a keyboard and mouse, continue with
"Step 10. Attach the Display Cable Toroid" on page 14.
Chapter 1. Setting Up the System
13