Installing An Internal Disk Drive - IBM eServer pSeries 610 6C1 Installation Manual

Installing an Internal Disk Drive

1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 34.
2. If you have not already done so, unplug the system unit power cables from the
electrical outlets.
3. If your server is a Model 6C1 (rack mount), place the server in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 35.
4. Remove the bezel as described in "Removing the Bezel" on page 39.
5. Remove the operator panel by grasping the release levers (1) and pull the
operator panel tray from the system unit.
6. With one hand, touch any metal surface of the chassis to minimize static electrical
charges, and then pick up the disk drive.
7. Insert the disk drive into the operator panel tray.
8. Align the screw holes on the disk drive with the screw holes on the operator panel
tray.
9. Install the four retaining screws.
10. Install the operator panel tray back into the system unit.
11. Connect all disk drive cables.
12. If you have other options to install, refer to "Option List" on page 36.
If you do not have other options to install; replace the bezel as described in
"Replacing the Bezel" on page 75.
1
Chapter 3. Installing Options in Your System
65