Step 15. Connect Any Additional External SCSI Devices
1. Locate the last SCSI device in the chain from the system unit. If a SCSI bus
terminator (1) is installed, remove it.
2. Connect the new SCSI cable (2) where you just removed the SCSI bus terminator.
3. Connect the other end of the SCSI cable (3) to the new SCSI device.
4. Connect the SCSI bus terminator (4).
5. Refer to the SCSI device documentation to set the SCSI device address. For future
reference, you can record the address in Appendix D, "System Records" on
page 109.
6. Repeat these steps for each additional external SCSI device you attach.
3
4
1
2
Chapter 1. Setting Up the System
19