2-6.5 Atx Power Supply Connector - SOLTEK SL-75DRV3/75DRV3+ User Manual

6. Power LED Connector:
CONNECTION: Connected to System Power LED.
FUNCTION: To supply power to "System Power LED".
7. Reset Switch Connector:
CONNECTION: Connected to the case-mounted "Reset Switch".
FUNCTION: To supply power to "Reset Switch" and support system
reboot function.
8. Speaker Connector:
CONNECTION: Connected to the case-mounted Speaker.
FUNCTION: To supply power to the case-mounted Speaker.

2-6.5 ATX Power Supply Connector

• This connector connects to an ATX power supply. The plug from the power
supply should only be inserted to ATX Power connector in a specific
orientation. Find the proper orientation and push it down firmly to make
sure that all pins are aligned.
• Your power supply should support at least 10mA on the 5V standby voltage.
It may cause difficulty to turn on the system power if the power supply does
not support the load.
• For Wake On LAN function, the power supply should support at least
720mA current.
+5V Standby
Power Good
+12V
GND
VCC
GND
VCC
GND
VCC3
VCC3
33
Chapter 2 Hardware Setup
VCC
VCC
-5V
GND
GND
GND
Power Supply on
GND
-12V
VCC3