Table of Contents
Advertisement
75DRV3/75DRV3+
5-3.1-3 Confirming Windows 2000 Installation
1. From Windows 2000, open the Control Panel from " My Computer"
followed by the System icon.
2. Choose the "Hardware" tab, then click the "Device Manager" tab.
3. Click the "+" in front of "SCSI & RAID Controllers hardware type." The
driver "Win2000 Promise FastTrak/FastTrak100-Lite Controller" should
appear, informing user that the controller driver is already installed.
5-3.2 Windows 95/98
5-3.2-1 Installing Drivers During Windows 95/98 Installation
The following three sections detail the installation of the FastTrak100-Lite
drivers while installing Windows 95/98 (with the FastTrak100-Lite controller
card already in place). If you're installing the FastTrak100-Lite drivers on a
system with Windows 95/98 already installed, see "Installing Drivers with
Existing Windows 95/98".
5-3.2-2 Windows 98
1. Connect your hard drive(s) for RAID Array to IDE3/IDE4, and enable
FastTrak100-Lite Controller with JP11. Configure the hard drive(s),
partition and format your hard driver(s).
2. Install Windows 98 normally.
3. After installation, go to "Start" menu and choose "Settings."
4. Form the "Settings" menu, choose "Control Panel."
5. In the "Controller Panel" window, double-click on the "System" icon.
6. In the "System" window, choose the "Device Manager" tab.
7. In the hierarchical display under "Other Devices" is a listing for "PCI
RAID Controller." Choose it and then press the "Properties" button.
8. Choose the "Driver" tab in the "Properties" window, choose "Update
Driver," and then press "Next."
9. Choose "Search for a better driver than the one your device is using
now (recommended), "then press "Next".
10. Choose "Specify Location," and then type "A:\WIN9x-ME" in the text box.
11. Insert the "FastTrak100-Lite Driver" diskette into the A: drive.
112
Advertisement
Table of Contents
