5-3.4 Windows Nt4.0 - SOLTEK SL-75DRV3/75DRV3+ User Manual

75DRV3/75DRV3+

5-3.4 Windows NT4.0

5-3.4-1 Installing Drivers During Windows NT 4.0 Installation
1. Connect your hard drive(s) for RAID Array to IDE3/IDE4, and enable
FastTrak100-Lite Controller with JP11. Start the system installation by
booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installation
diskettes.
b) Other bootable Floppy: boot from the bootable floppy and type
"WINNT /B". After files have been copied, the system will reboot. On
the reboot, press the "F6" key when the message "Setup is inspecting
your computer's hardware configuration..." appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press the "F6"
key when the message "Setup is inspecting your computer's hardware
configuration..." appears.
2. When the "Windows NT Setup" windows is generated, press "S" to Specify an
Additional Device(s).
3. Press "O" to select "Other" and press the "Enter" key.
4. Insert into drive A the Promise Technology ® FastTrak100-Lite driver
diskette that you have made from the support CD: and press "Enter"
key.
5. Choose "Win NT Promise FastTrak100-Lite (tm) Controller" from the
list that appears on screen, then press the "Enter" key.
6. The Windows NT Setup screen will appear again saying "Setup will load
support for the following mass storage devices:" The list will include
"Win NT Promise FastTrak100-Lite (tm) controller".
Note:
If you need to specify any additional devices to be installed, do so
at this time. Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will now
load all device files and then continue the Windows NT installation.
8. After a successful installation, the "SCSI Adapter Setup" box will show
that the "Win NT Promise FastTrak100-Lite (tm) Controller" driver has
been installed.
116