Programming
Annunciator addressing is specific to the MS-9200UDLS control panel. The following table
describes the annunciator addresses and the corresponding addressable devices that will be annun-
ciated at each annunciator address.
The MS-9200UDLS must be programmed for the annunciators installed on the system. Refer to
"Annunciators" on page 105 for information on annunciator programming. Make certain to
program the annunciator addresses that have been physically installed on the system.
NOTE: The 8 General System Status Points include the following:
• General Alarm
• General Trouble
• General Supervisory
• Alarm Silenced
• System Off Normal
• AC Loss
• Battery Fault
• NAC Fault
106
ACS Annunciator Address
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Annunciator Displays the Following Points
8 General System Status Points & Zones 1 - 56
Zones 57 - 99 & 4 NACs
SLC Loop, Module Addresses 1 - 64
not used
SLC Loop, Module Addresses 65 - 99
not used
not used
SLC Loop, Detector Addresses 1 - 64
not used
SLC Loop, Detector Addresses 65 - 99
not used
not used
not used
not used
not used
not used
not used
not used
not used
8 General System Status Points & Zones 1 - 56
Zones 57 - 99 & 4 NACs
SLC Loop, Module Addresses 1 - 64
not used
SLC Loop, Module Addresses 65 - 99
not used
not used
SLC Loop, Detector Addresses 1 - 64
not used
SLC Loop, Detector Addresses 65 - 99
not used
not used
not used
MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Master Programming Level