Section 6: Projector Menus
1
Figure 6-17 Advanced Setup: Lamp Power / LiteLOC™ Setup Window
Table 6.12 Advanced Setup: Lamp Power / LiteLOC™ Setup
Control
1: Power %
2: Enable
LiteLOC™
3: Light Meter - Set
Target
4: Amps, Volts,
Watts, ~FL or
2
~cd/m
, Hours
5: Text Region
6: Light Bar
6-24
2
3
Description
The percentage of power to supply to the lamp. See 6.13.2 for the valid Lamp Power ranges for
specific lamp types.
Applies LiteLOC
to the current channel.
™
Automatically enables LiteLOC
Light Meter value is an arbitrary unit of measure, not lumens or fL.
Lamp current in amperes, lamp voltage in volts, lamp power in watts, approximate Foot Lamberts
reading on the light sensor (assuming a calibration was performed), and hours on current lamp.
The current light sensor reading in arbitrary units-of -measure and does not represent actual lumens
or fL.
The current light intensity and LiteLOC
4
and maintains the current brightness level as long as possible. The
™
™
target.
5
LiteLOC™
6
Target
Light
Intensity
CP2220 User Manual
020-100420-07 Rev.1 (1-2012)