Adjust Tilt And Level The Projector - Christie CP2220 User Manual

Section 2: Installation and Setup
3. Attach the supplied safety strap to the back of the projector and fasten it to its mounting surface. Use of the
strap is mandatory to prevent the projector from tipping when a lens or auxiliary lens mount is installed.
NOTE: If you are using the optional rack stand, it is strongly recommended you use the hold down clamp
(116-100101-01) in addition to the rear safety strap to firmly secure the projector's rear feet.
2.6

Adjust Tilt and Level the Projector

WARNING! The projector's rear safety strap must be in place before you adjust the projector
feet.
The CP2220 lens should be centered and parallel with the screen to ensure optimum lens performance with
minimal offset. If this position is not possible, it is better to rely on offset rather than extra tilt.
Use a protractor to measure the degree of screen tilt and then extend or retract the projector feet to match this
angle.
NOTE: To ensure safe lamp operation and the proper positioning of the
liquid cooling reservoir, the front-to-back tilt of the projector must not
exceed 15°.
To adjust the vertical or horizontal position of the projector, extend or retract
the adjustable feet on the bottom of the projector by rotating them. When
you finish the adjustment, tighten the lock nut.
2-6
Figure 2-2 Position the Projector
Figure 2-3 Adjust Feet
CP2220 User Manual
020-100420-07 Rev.1 (1-2012)