Projection Lens; Input Panel - Christie CP2220 User Manual

Lamp Door and Lamps
Provides access to the lamp. The lamp door must remain closed and locked for normal operation. Lamp
replacement should only be performed by qualified technicians.
The projector is designed to operate with 2.0kW and 3.0kW lamps. See
complete list of available lamp
LED Status Indicators
Provide information about the status of the projector. See
projector status.
Motorized Auxiliary Lens Mount (optional)
An optional auxiliary lens mount can be installed adjacent to the primary lens mount to provide motorized
positioning of a 1.25x Anamorphic lens or a 1.26 Wide Converter lens in front of the primary lens. The Wide
Converter lens "zooms" the image from flat to scope image formats. The Anamorphic lens horizontally
spreads the image back into its wider 2.39:1 "scope" image and is most typically used in side-masking theatres
or on larger screen sizes.

Projection Lens

A variety of lenses can be used with the CP2220 projector. See
available lenses.
RS-422 Connector
Connects the motorized lens mount to the projector.
Security Locks
Prevent unauthorized access to projector components.

Input Panel

The input panel on the rear of the projector connects the projector to external devices such as cinema servers,
computers, and controllers.
PIB Faceplate Connections:
• Ethernet: Use the 10Base-T/100Base-TX Ethernet port for network connection to the projector.
• GPIO: Connect external I/O devices, such as the Christie ACT, for remote control of a limited number of
projector functions. See
• DVI-A / DVI-B: Connect a variety of non-cinema video and graphics sources to either of these identical sin-
gle-link DVI ports. These are single-link ports for single-link cables/connectors only. The connectors can be
used together as a twin-link DVI port.
• HD-SDI A/HD-SDI-B: Connect a variety of high-definition cinema sources to these SMPTE 292M bit-
serial standard interface BNCs. The connectors can be used together to deliver Dual Link HD-SDI following
the SMPTE 372M standard.
• SCCI: A Simple Contact Closure Interface (SCCI) port that provides the following functions upon a simple
dry contact closure: Lamp On/Off and Douser Open/Closed. See
for SCCI pinouts.
• RS232 ICP: Connect a PC or laptop for direct DLP communication. Trained users required.
CP2220 User Manual
020-100420-07 Rev.1 (1-2012)
types.
3.3 Connecting Devices to the GPIO Port
Section 2: Installation and Setup
Appendix A: Specifications
5.3 Projector Power States
Appendix A: Specifications
for GPIO pinouts.
3.2 Connecting Devices to the SCCI Port
for a
for information about
for a list of
2-3