Replacing Engine Oil Filter; Replacing Transmission Oil Filter [Hst] - Kubota RTV1140 CPX Operator's Manual

62 PERIODIC SERVICE
BReplacing Engine Oil Filter
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface and raise the cargo
bed.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber seal of the
new filter.
4. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
(1) Engine oil filter
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
BReplacing Transmission Oil Filter [HST]
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface, raise the cargo bed,
and mount the safety support.
2. Remove the oil filters.
3. Put a film of clean transmission oil on the rubber seal
of the new filter.
4. Quickly tighten the filter until it contacts the mounting
surface, then, with a filter wrench, tighten it an
additional 1 turn only.
5. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
6. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
7. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
(1) Transmission oil filter (HST) (Yellow color)
A To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.