Yamaha YZ426F(M)/LC Owner's Service Manual page 130

Fasten the TPS lead under the
coupler to the frame with a plas-
tic locking tie.
Ò Pass the carburetor breather
hose and overflow
between the connecting rod and
cross tube (frame).
˜ Fasten the neutral switch lead
and oil hose together with a
plastic locking tie and cut off the
tie end.
ˆ Fasten
the cylinder
breather hose and neutral switch
lead to the frame with a plastic
locking tie.
Ø Fasten the neutral switch lead to
the frame with a plastic band.
CABLE ROUTING DIAGRAM
∏ Fasten
the
breather hose with the hose
holder.
ΠPass the clutch cable through
hose the cable guide.
 Fasten the neutral switch lead
and CDI
together with a plastic band.
Í Pass the clutch cable on the
inside the
breather hose.
Ê Pass
head the
breather hose along the inner
side of the radiator pipe.
Ë Pass the radiator breather
hose from the right side of the
frame to the left side, over
radiator pipe 1, along the inner
2 - 22
cylinder head
◊ Pass
magneto lead
„ Pass the neutral switch lead
cylinder head
cylinder head
SPEC
side of radiator hose 4 and
the radiator, and between the
lower engine bracket, crank-
case, oil hose and the frame.
the clutch
between the frame and radia-
tor and over the lower boss on
the radiator.
and CDI magneto lead over
the middle radiator mounting
boss. Then, pass the decom-
pression cable under the mid-
dle radiator mounting boss
and along the left side of the
neutral switch lead and CDI
magneto lead.
cable