Manual Dialing When the Remote Modem is Configured for Manual Answer
If you are originating a call using a telephone and the remote modem is configured for Manual
Answer, perform the following procedure.
Once the remote telephone is answered by the remote user, you must both decide when to place
the modems into Data mode. You must both select Tlk/Data at approximately the same time and
hang up the handset to begin the handshaking sequence.
If the handshake is successful, the modems are in Data mode and OnLine appears on the LCD.
Once the modems are online, the status messages listed in
display.
It is not necessary to specify an originating or answering modem when dialing via the DCP
because the answering modem detects that it is receiving a ringing voltage and automatically
defaults to Answer mode.
3920-A2-GH30-40
On both modems, the Line Current Disconnect configuration option
(refer to the Line Dialer section in Chapter 5, Configure Branch)
must be set to Disable.
If the remote modem is not a 3900 Series modem, then the remote
user must consult that modem's operator's manual to perform a
similar operation.
October 1998
NOTE
NOTE
Table 3-3
appear on the Top-Level
Talk/Data Branch
11-3