Change Directory - Paradyne COMSPHERE 3920Plus Technical Reference Manual

If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem
to primary leased-lines and the LCD displays the status message Command Complete.
Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this
function forces the modem to backup networks and the LCD displays the status message
Command Complete.
To exit this function and remain in the Call Setup branch, press the
to the Top-Level menu, press the

Change Directory

Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile
memory locations that allow you to store up to 24 telephone numbers. Each directory location
can accept up to 40 characters; this includes the telephone number and dial command modifiers.
Any telephone number dialed using the DCP Dial command must appear in a directory location.
To access Change Directory from the Call Setup branch, make the following selections:
Press the
Change_Directory.
The phone number listed in directory location 1 appears. Select Nxt to display other directory
locations.
3920-A2-GH30-40
key.
If the modem is operating on leased lines and has a dial line
attached for dial backup purposes, it is required that directory
location 1 contain the telephone number used for dial backup.
Call Setup:
Change_Directory
F1 F2 F3
key until Change_Directory appears. Press any function key to select
01:551234z
" #
Nxt
F1 F2 F3
October 1998
NOTE
<
Call Setup Branch
key. To exit and return
10-7