Paradyne COMSPHERE 3920Plus Technical Reference Manual page 171

Viewing DC Broadcast Clone Results
From the Choose DLL Type screen, press the
the results of the last DC_Broadcast clone operation. If the message Trib List Empty appears,
this indicates that a multiple download was never initiated.
The address field (xxx) displays the network management address of one of the remote modems.
Pressing the F1 key allows you to select various remote modems to determine the download
result for those modems (Pass or Fail).
Clone Remote in Multipoint Configurations
A Trellis Multipoint (TMp) control modem can be used to download firmware to just one
tributary modem (Single) or to all of its tributary modems (Multiple).
Before using Clone Remote in multipoint configurations (Single or Multiple), perform the
following:
• Make sure the 392xPlus modems have an established leased-line connection using the
• Make sure the remote modem's Access From Remote configuration option is enabled
• For Single download configurations, know the remote access password and the network
3920-A2-GH30-40
Choose DLL Type >
DC_CloneResults
F1 F2
DC Clone Results
Nxt xxx
F1 F2
A Trellis Multipoint (TMp) tributary modem cannot download
firmware to its control modem. To download firmware to a TMp
control modem use a point-to-point dial connection, an NMS, or a
PC controller.
Trellis Multipoint (TMp) modulation (refer to the Leased Line section in Chapter 5,
Configure Branch).
(refer to the Misc section in Chapter 5, Configure Branch).
management address of the remote tributary modem that will receive the download. Refer
to the Misc section in Chapter 5, Configure Branch, for a description of the remote access
password (RemAccssPasswrd) configuration option and the network management address
(NetMngmtAddress) configuration option.
October 1998
F3
key until DC_CloneResults appears to view
Pass
F3
NOTE
Control Branch
7-11