Paradyne COMSPHERE 3920Plus Technical Reference Manual page 166

COMSPHERE 392xPlus Modems
The port field (xxxxx) displays the currently selected interface. Valid interface selections are
Port1, Port2, Port3, Port4, and depending on the set value of the Diagnostic Connection
configuration option, CC (NMS Control Channel), or DC (Diagnostic Channel). Refer to Diag
Connection configuration option in the Misc section of Chapter 5, Configure Branch.
Press the F1 key until the appropriate digital interface appears. Select the appropriate interface
by pressing the corresponding function key.
After selecting the desired interface, the message Command Complete appears on the bottom
line of the LCD and the selected interface appears in the xxxxx field.
To exit this function and remain in the Control branch, press the
the Top-Level menu, press the
Make Busy/Remove Make Busy
The Make Busy function forces the modem off-hook so it cannot answer a call. This is often
used with PBX systems to permit the busy out of a PBX port for rotary or hunt groups.
To access Make Busy from the Control branch, make the following selections:
Press the
The modem is now in a forced busy condition. Command Complete appears on the LCD.
7-6
key.
The Port 1 interface is the only display allowed on the 3921Plus
modem in Singleport mode, therefore the entire EIA LEDs branch is
masked.
To prevent violations of FCC and DOC regulations, this
function must only be used behind a user's PBX.
Control:
Make_Busy
F1 F2 F3
key until Make Busy appears. Select Make Busy.
Make Busy
Command Complete
F1 F2 F3
October 1998
key. To exit and return to
NOTE
WARNING
3920-A2-GH30-40