Paradyne COMSPHERE 3920Plus Technical Reference Manual page 186

COMSPHERE 392xPlus Modems
To access Rem_Digital_Loop from the Test branch, make the following selections:
Press the
Select the appropriate port by pressing the corresponding function key. Press the
scroll other ports into view.
This screen does not appear in Singleport mode.
The message Started appears on the LCD, and the Test LED lights.
If OtherTestActive appears on the LCD, another test is in progress. Select Abort to clear the
current test and try again. If the Test Timeout configuration option is enabled, Test Timeout
appears at the conclusion of the test. If it is disabled, the test operates until aborted. For more
information on the Test Timeout configuration option, refer to the Test section in Chapter 5,
Configure Branch.
To exit this function and remain in the Test branch, press the
Top-Level menu, press the
8-6
Test:
Rem_Digital_Loop
F1 F2 F3
key until Rem_Digital_Loop appears. Press any function key to start this test.
Pick Test Port
Port1 Port2
F1 F2 F3
Test:P1:Rem Loop
Started
F3
F1 F2
key.
A remote digital loopback should always be terminated at the local
unit's DCP using the Abort function of the Test branch. If it is
necessary to end a remote digital loopback some other way, use
Abort on the remote unit's DCP, an NMS test abort, or a power
reset of the remote unit.
October 1998
>
key. To exit and return to the
NOTE
key to
3920-A2-GH30-40