Paradyne COMSPHERE 3920Plus Technical Reference Manual page 165

To enable or disable the modem's data transmitter function on all ports, press the appropriate
function key, F1 (Enable) or F3 (Disable). When the message Command Complete appears,
press the
To change the data stream on all ports again, press the F1 key.
or
To exit this function and remain in the Control branch, press the
the Top-Level menu, press the
EIA LEDs
This function allows the front panel EIA LEDs to display and change the activity of a selected
digital interface. Use the EIA LEDs function to change the port that controls the front panel
LED.
Based on the modem's configuration, the following conditions exist:
• The CC or DC selection is not available if the Diagnostic Connector configuration option
• The CC or DC interface is not available on the 3921Plus modem. The CC or DC activity
• Ports 3 or 4 are not available in the DTE Bridge mode.
• Ports 2, 3, and 4 are available in TDM/MSD mode.
To access EIA LEDs from the Control branch, make the following selections:
Press the
3920-A2-GH30-40
key to clear the message.
Select DS Port
All
F1 F2
is disabled. Refer to the Diag Connection configuration option in the Misc section of
Chapter 5, Configure Branch.
is monitored on the SDU in the 3000 Series carrier.
Control:
EIA_LEDs
F1 F2
key until EIA LEDs appears. Select EIA LEDs.
EIA LEDs:xxxxx
Port1
F1 F2
October 1998
>
F3
key.
F3
>
Port2
F3
Control Branch
key. To exit and return to
7-5