Paradyne COMSPHERE 3920Plus Technical Reference Manual page 125

V25b NewLineChr: CR+LF
End CR+LF CR LF
This configuration option only appears when DTE Dialer is configured for V.25bis Async.
V.25bis New Line Character. Sets the modem for the command line terminator used by the DTE in V.25bis Async mode.
The modem responds to the DTE using the same line terminator.
The AT command is S-Register S64 = n, where n is 0 for carriage return and line feed, 1 for carriage return, or 2 for line
feed.
Line Dialer — Singleport Mode
The Line Dialer configuration options establish parameters used by the modem to answer or
originate calls.
Table 5-9 shows each Line Dialer configuration option as it appears on the LCD, with the Sync
Leased factory default setting (the default value if the modem is just being installed) shown
following the colon ( : ) on the first line and with all available selections listed on the second line.
Following this is a description of the configuration option. Factory default settings are listed in
Appendix F,
AutoAnswerRing#: 1
Nxt 1 Disable 2 4 6 8 10
Auto-Answer Ring Count. Determines the number of rings necessary before the answering modem answers an
incoming call. For example, if this option is set to 2, then the answering modem answers after the second ring.
Disable – If selected, the modem must be answered using either the DCP's Answer command or Tlk/Data function or
via AT commands. Refer to Chapter 11,
NOTE: Although DCP selections are limited (1, 2, 4, 6, 8, or 10), values set by AT commands can display from 1 to
255 rings.
NOTE: The range of allowable values may be restricted in some countries.
The AT command for Disable is S0 = 0.
The AT command is S-Register S0 = n, where n is a ring count from 1 to 255.
Dialer Type: Tone
Nxt Tone Pulse
Dialer Type. Selects either tone (DTMF) dialing or pulse (rotary) dialing mode.
NOTE: Pulse Mode is disabled in Denmark and Sweden.
The AT command for Tone is T.
The AT command for Pulse is P.
3920-A2-GH30-40
DTE Dialer Configuration Options — Singleport Mode A
A
Default Configuration
Line Dialer Configuration Options — Singleport Mode A
Talk/Data Branch, for more on Manual Answer.
Table 5-8
(5 of 5)
Options.
Table 5-9
(1 of 4)
October 1998
Configure Branch
5-49