Paradyne COMSPHERE 3920Plus Technical Reference Manual page 203

Talk/Data Branch
The Talk/Data function is not available in TMp Control mode.
The Talk/Data branch of the Top-Level menu allows you to switch the modem between Talk
mode and Data mode when manually dialing using either the DCP or an externally attached
telephone.
To add an external telephone to your modem, use an external "Y" cable to connect the phone
line to both the modem and the telephone (refer to Appendix C,
not supplied with your modem.
On initial power-up, the modem is in Data mode. When in Data mode, the modem is connected
and data can be transmitted or received. When in Talk mode, the modem is disconnected and
you are free to use the external telephone. This function is not available for Model 3920-A2 or
3921 modems.
Status Configure
The following sections describe the uses of the Talk/Data function.
3920-A2-GH30-40
Talk/Data Branch
Talk/Data Branch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Manual Dialing When the Remote Modem is Configured for
Auto-Answer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Manual Dialing When the Remote Modem is Configured for
Manual Answer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PList Control Test
October 1998
"Status"
SubHS Call_Setup
Tlk/Data
11
11-1
11-2
11-3
Pin Assignments). This cable is
Security Remote
11-1