Paradyne COMSPHERE 3920Plus Technical Reference Manual page 262

COMSPHERE 392xPlus Modems
S-Register
S90 DTE Rate = VF. Register allows the DTE's data rate to be equal to the VF
(telephone line) data rate. If Enabled, the data rate between the DTE and
modem is the same as the modem's VF data rate. As a result, when the
modem is in Data mode, the speed of the data passed between the modem
and DTE occurs at the VF data rate.
Register has the following values:
0 = Disable
1 = Enable
The factory setting is Disable.
S92 V.29 Train On Data. When enabled, the modem receiver can train based upon
the incoming data or a training sequence from the distant modem. This
function is necessary for a remote (tributary) modem in a V.29 multipoint
network and is recommended for a control modem as well.
Register has the following values:
0 = Disable
1 = Enable
The factory setting is Disable.
S93 V.29 Retrain. When enabled, the modem transmits a training sequence
whenever it receives one. This configuration option should normally be
disabled for control modems.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S94 V.29 Link Configuration. Selects point-to-point or multipoint operation.
Register has the following values:
0 = Point-To-Point
1 = Multipoint
The factory setting is Point-To-Point.
S95 Trellis Multipoint (TMp) Train Time. Defines the length of time energy is sent
from the tributary modem to the control modem. More severe line conditions
require longer time selections.
Register has the following values:
0 = 10 milliseconds
1 = 20 milliseconds
2 = 50 milliseconds
3 = 100 milliseconds
4 = 200 milliseconds
5 = 300 milliseconds
The factory setting is 0 (10 milliseconds).
14-30
Table 14-3
(14 of 15)
392xPlus S-Registers
Description
October 1998
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
Leased
Configure\Edit\
Leased
Configure\Edit\
Leased
Configure\Edit\
Leased
3920-A2-GH30-40