Paradyne COMSPHERE 3920Plus Technical Reference Manual page 95

Line Dialer — Multiport Mode l
The Line Dialer configuration options establish parameters used by the modem to answer or
originate calls.
Table 5-2 shows each Line Dialer configuration option as it appears on the LCD, with the Sync
Leased factory default setting (the default value if the modem is just being installed) shown
following the colon ( : ) on the first line and with all available selections listed on the second line.
Following this is a description of the configuration option. Factory default settings are listed in
Appendix F,
AutoAnswerRing#: 1
Nxt 1 Disable 2 4 6 8 10
Auto-Answer Ring Count. Determines the number of rings necessary before the answering modem answers an
incoming call. For example, if this option is set to 2, then the answering modem answers after the second ring.
NOTE: The range of allowable values may be restricted in some countries.
Disable – If selected, the modem must be answered using either the DCP's Answer command or the Talk/Data function.
Refer to Chapter 11, Talk/Data
Dialer Type: Tone
Nxt Tone Pulse
Dialer Type. Selects either tone (DTMF) dialing or pulse (rotary) dialing mode.
NOTE: Pulse Mode is disabled in Denmark and in Sweden.
DialTone Detect: Enable
Nxt Enable Disable
Dial Tone Detect. Sets the modem for dial tone detection (Enable) or blind dialing (Disable).
NOTE: It may not be possible to disable Dial Tone Detect in some countries.
Enable – Modem disconnects the call if a dial tone is not detected within 10 seconds and displays No Dial Tone on
both the LCD and asynchronous DTE terminal.
Disable – Modem dials a call whether or not it detects a dial tone on the line. This is known as blind dialing. The period
of time the modem waits before dialing is specified in the Blind Dial Paus configuration option.
3920-A2-GH30-40
Default Configuration
Table 5-2
Line Dialer Configuration Options — Multiport Mode l
Branch, for more on Manual Answer.
October 1998
Options.
(1 of 3)
Configure Branch
5-19