Paradyne COMSPHERE 3920Plus Technical Reference Manual page 150

COMSPHERE 392xPlus Modems
Miscellaneous Configuration Options — Singleport Mode A
Access frm Remt: Enable
Nxt Enable Disable
Access from Remote. Determines if your modem's DCP can be accessed by a remote modem via the VF line.
CAUTION: If this configuration option is disabled, the modem cannot be accessed by another modem.
Enable – Allows access from a remote modem.
Disable – Does not allow access from a remote modem.
NOTE: The remote modem must be a Model 3920Plus or Model 3921Plus modem.
The AT command is S-Register S55 = n, where n is 0 for Enable and 1 for Disable.
RemAccssPasswrd: 00000000
Nxt " 00000000
Remote Access Password. Allows the entry of a password for establishing control of a remote modem from the DCP of
a local modem. The same password must be used in both the local and remote modem.
CAUTION: A remote access password should be selected for security purposes.
NOTE: If the Access from Remote configuration option is set to Disable, the password has no effect.
The AT command equivalent is S-Registers S56 = n, S57 = x, S58 = y, and S59 = z, where n is the leftmost pair of
digits, x is the second pair of digits, y is the third pair of digits, and z is the rightmost pair (or fourth) pair of digits. For
example, if the remote access password is 12345678, then the value for S56 is 1 and 2, and the value for S59 is 7
and 8.
Dir#1_Callback: Disable
Nxt Disable Enable
Directory Location 1 Callback. This configuration option controls whether or not the modem's single number callback
function is used.
Disable – Modem does not use the single number callback function.
Enable – Modem answers a call, disconnects, and dials the number stored in directory location 1.
NOTE: This function is disabled if dial access security is enabled.
The AT Command to Disable is S-Register S67 = 0.
The AT Command to Enable is S-Register S67 = 1.
Callback Delay: Disable
Nxt Disable 20sec 40sec 1min 2min 3min
This configuration option only appears if Dir#1 Callback is enabled.
Callback Delay. Determines the amount of time between disconnect confirmation and callback origination.
Disable – No time is specified. The default delay is 10 seconds.
20sec – 3min – The delay is set to the specified duration.
The AT command is S-Register S60 = n, where n is 0 for Disable, 1 for 20sec, 2 for 40sec, 3 for 1min, 4 for 2min, and
5 for 3min.
5-74
Table 5-14
(2 of 5)
October 1998 3920-A2-GH30-40