Paradyne COMSPHERE 3920Plus Technical Reference Manual page 240

COMSPHERE 392xPlus Modems
AT
Command
Xn Extended Result Code, Dial Tone Detect, and Busy Tone Detect Configuration
Options.
Extended Result Code:
Enable
Disable
Add/EC
Add/V42,MNP
Use DTE Rate
Dial Tone Detect:
Enable
Disable
NOTE: It may not be possible to disable Dial Tone Detect in some countries.
Busy Tone Detect:
Enable
Disable
Yn Long Space Disconnect.
Y0
Y1
Zn Reset and Load Active.
Z0
Z1
Z2
Z3
14-8
Table 14-2
392xPlus AT Commands
Description
Extended
Result Code:
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42.MNP
X7 Use DTE Rate
Displays all result codes listed in
control suffix.
Only displays OK, CONNECT, RING, NO CARRIER,
ERROR.
Displays result codes with /EC suffix.
Displays result codes with V.42 or MNP suffix.
Displays DTE data rate instead of line rate.
Sets the modem for dial tone detect.
Sets the modem for blind dialing.
Modem monitors for busy tone.
Modem ignores busy tone.
Disable. Ignores long space.
Enable. Disconnects if long space is detected. Enables transmission
of a long space.
Loads configuration options from Active (Saved) to Active
(Operating).
Loads configuration options from Customer 1 to Active (Operating).
Loads configuration from Customer 2 to Active (Operating).
Loads configuration options from Active (Saved) to Active
(Operating) and performs a reset.
(3 of 10)
Dial Tone Busy Tone
Detect: Detect:
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
Table 14-1
October 1998
DCP LCD
Command
Sequence
Extended Result
Code:
Configure\Edit\
DTE Dialer
Dial Tone Detect:
Configure\Edit\
Line Dialer
Busy Tone
Detect:
Configure\Edit\
Line Dialer
except for error
Configure/Edit/
Line Dialer
Control\Reset
3920-A2-GH30-40