Change Directory - Paradyne COMSPHERE 3910 Installation And Operation Manual

If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem to
primary leased lines and the LCD displays the status message Command Complete.
Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this
function forces the modem to the backup network and the LCD displays the status message
Command Complete.

Change Directory

Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile
memory locations that allow you to store up to 24 telephone numbers. Each directory location can
accept up to 40 characters; this includes the telephone number and dial command modifiers. Any
telephone number dialed using the DCP Dial command must appear in a directory location.
To access Change Directory from the Call Setup branch, make the following selections:
Press the
Change_Directory.
The phone number listed in directory location 1 appears. Select Nxt to display other directory
locations.
3910-A2-GN32-30
Dial Standby
Command Complete
F1 F2 F3
If the modem is operating on leased lines and has a dial line
attached for dial backup purposes, it is required that directory
location 1 contain the telephone number used for dial backup.
Call Setup:
Change_Directory
F1 F2 F3
key until Change_Directory appears. Press any function key to select
01:551234
Nxt
F1 F2 F3
November 1996
NOTE
<
DCP Operation
3-59