Read Printed Barcodes - CipherLab CP60 Reference Manual

2.1.4. READ PRINTED BARCODES

Before you start collecting data, configure the reader module(s) using Reader
Configuration, or skip the configuration and go straight to collect data using Reader
Demo.
To collect data:
1) Use Reader Config to configure the reader module as described in
2) Launch the scanning utility Reader Demo as described in
The provided application Reader Demo displays the barcode which was last decoded. If
you would like to collect more or all of the decoded data for further use, enable
Emulation and run a text editor on the mobile computer or connect the mobile computer
to a remote computer so there is somewhere to admit the decoded data.
3) Locate the scanning window on the top of the mobile computer. Point it at the printed
barcode to read while holding the mobile computer steady a few inches from the
barcode.
4) Press the scan key (or either side trigger) on the mobile computer.
The scanning light beams to read the printed barcodes.
The scanning light goes off once data is decoded, or decoding timeout is reached.
Figure 16: Read printed barcodes
5) The decoded data will display in Reader Demo, or display in the target destination as
configured in Reader Configuration.
Chapter 2 Data Capture
Barcode Reader.
Launch Reader Demo.
Keyboard
83