Read Printed Barcodes - CipherLab CP60 Reference Manual

CP60 Mobile Computer

2.3. READ PRINTED BARCODES

Before you start collecting data, configure the reader module(s) using Reader Config as
described in Configure Reader
To collect data:
1) Use Reader Config to configure the reader module to meet your needs.
2) Launch the reader module Reader Demo as described in
The provided application Reader Demo displays the barcode which was last decoded. If
you would like to collect more or all of the decoded data for further use, run a text editor
on the mobile computer or connect the mobile computer to a remote computer so there
is somewhere to admit the decoded data. See
3) Locate the scanning window on the top of the mobile computer. Point it at the printed
barcode to read while holding the mobile computer steady a few inches from the
barcode.
4) Press the scan key (or either side trigger) on the mobile computer.
The scanning light beams to read the printed barcodes.
The scanning light goes off once data is decoded, or decoding timeout is reached.
Figure 14: Read printed barcodes
5) The decoded data and barcode type will display in their respective fields.
80
or skip the configuration and go straight to collect data.
Launch Reader
Data Output for related settings.
Reference Manual
Module.