Table of Contents
Advertisement
READ PRINTED BARCODES & RFID TAGS
Before
you
start
ReaderConfigMobile.exe as described in
go straight to collect data.
To collect data:
1) Launch the reader module(s) as described in
2) Configure the reader module(s) if you want to.
3) Run a text editor on the mobile computer or connect the mobile computer to a remote
computer so there is somewhere to admit the decoded data.
4) Find the scanning window on the top of the mobile computer. Point it at the printed
barcode to read while holding the mobile computer steady a few inches from the
barcode.
OR
Find the scanning window on the top of the mobile computer. Tap (slightly contact) the
scanning window with the RFID tag.
5) Press the physical SCAN key (or either side trigger) on the mobile computer.
The scanning light beams to read the printed barcodes, or RFID tags are read.
The scanning light goes off upon data decoding or decoding timeout.
Figure 17: Reading Printed Barcodes
out
collecting
data,
Configure
configure
the
reader
Reader(s), or skip the configuration and
Launch Reader
Module(s).
Data Capture
module(s)
using
59
Advertisement
Table of Contents
