CipherLab CP60 Reference Manual page 113

To write data into an RFID tag:
1) On the HF RFIDConfig main view, tap the green arrow next to Read / Write Block.
2) Tap Write tabbed page.
3) Input the data you would like to write in the blank field.
4) Place the RFID tag to write in proximity to the upper half of the mobile computer's back
cover, where the RFID reader module is installed.
5) Press the scan key (or side trigger) on the mobile computer.
If data failed to write into the RFID tag, an error message will display in the Response
field below.
Check to write
the data in
hexadecimal
format
If a failure occurs
during data write, an
error message will be
displayed in the
Response field
Tap to leave the
test scan page
Note:
(1) Generally the RFID data will be written to the user block, which is free for custom use.
If you wish to write the data to a non-user block such as the lock block, select Enter
hexadecimal to write data in hex values in case the block to write involves any invisible
characters.
(2) By default, the string will be written to the tag from byte 0 of the default block. Different
RFID tags may have different default blocks, amount of bytes in each block and number
of blocks. The written data will be truncated to fit inside the blocks of the targeted RFID
tag. Therefore part of the data may be discarded when it comes to the end of a block.
Refer to RFID Tag Default Block.
Chapter 2 Data Capture
Set the block to
write data to
Input the data to
write to the RFID
tag
99