4.2.4 Commands for Setting Camera Parameters
4.2.4.1 Exposure Time Control Mode
Purpose:
To set the exposure time control mode or to read the current exposure time control mode
setting. See section
Type:
This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:
Basler A500
k
PRELIMINARY
3.2
for an explanation of exposure time control modes.
Cmd-ID
R/W-Flag
0xA0
1
Cmd-ID
R/W-Flag
0xA0
0
Cmd-ID
R/W-Flag
0xA0
0
None
Byte 1
An ID that specifies the exposure mode
(see the table below).
ID
Exposure Time Control Mode
0x00
Free-run, Programmable
0x04
ExSync, Level-controlled
0x05
ExSync, Programmable
0x06
ExSync, Edge-controlled
0x08
Free-run, VGA (A504k/kc only)
Configuring the Camera
Data Length
Data
1
Data Length
Data
1
1 Byte
Data Length
Data
1
1 Byte
-
4-11