Area Of Interest With The Vga Monitor Output (A504K/Kc Only) - Basler WOOD BURNING FIREPLACE Wood Burning Fireplace

AOI Starting Column, AOI Width, AOI Starting Line, AOI Height: The values come directly from
the AOI registers of the camera. The AOI values are located right-justified in each 16 Bit stamp.
Unused Bits are set to 0.
The stamp is not applied
• if a test image is active, or
• if the exposure mode is set to free-run, VGA.
You can activate or deactivate the Area of Interest Stamp using either the Camera Configuration
Tool Plus (see section 4.1) or binary commands (see section
Dynamic Area of Interest (A504k/kc, A503k
3.11.4 Area of Interest with the VGA Monitor Output (A504k/kc
Only)
In VGA exposure mode, the
maximum frame rate remains
60 fps (frames per second),
regardless of the area of in-
terest selected.
In the VGA exposure mode, 1280 x 960
pixels of the image are scaled down to 640
x 480 pixels. These always transferred via
the VGA monitor output, even if a smaller
area of interest is selected. If an area of
interest is set, the pixels inside the area of
interest display an image. The pixels
outside the area of interest are black.
Via the Camera Link output, only the pixels
inside the area of interest are transferred.
Basler A500
k
PRELIMINARY
Only)").
black
pixels
Basic Operation and Features
4.2.4.15 "Area of Interest Stamp and
area of interest
Figure 3-30: Area of Interest with VGA
Monitor Output
3-43