Camera Reset Command; Power Control Command - Basler WOOD BURNING FIREPLACE Wood Burning Fireplace

Configuring the Camera

4.2.10 Camera Reset Command

Purpose: Initiates a camera reset. The behavior is similar to a power up reset.
Type: This is a write only command.
Write Command:
Response:
Data Format:

4.2.11 Power Control Command

Purpose: To set the camera to standby mode or to fully functional mode. See section
time.
Type: This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:
4-32
PRELIMINARY
Cmd-ID R/W-Flag
0x42 0
None
Byte 1 Low byte
Byte 2 High byte
Cmd-ID R/W-Flag
0xA2 1
Cmd-ID R/W-Flag
0xA2 0
Cmd-ID R/W-Flag
0xA2 0
None
Byte 1 An ID that specifies the power mode (see the table below).
ID Power Mode
0x00 Camera in standby
0x01 Camera fully functional
Data Length Data
2 2 Bytes
0xCF is always used
0x07 is always used
Data Length Data
1
Data Length Data
1 1 Byte
Data Length Data
1 1 Byte
on power up
2.9
-
Basler A500
k